Restore Factory Default Configuration on the Netgear ProSafe FVS318G

    June 11th, 2019

    Step 1

    Power on the Netgear ProSafe FVS318G by plugging it to the power adapter.

    Step 2

    Using a pin or paperclip, press and hold the Factory Defaults button for 10 seconds and the Test LED will begin to flash.

    Step 3

    Wait a few minutes while the Netgear ProSafe FVS318G restores to the factory default settings.

    Was this article helpful?

    Send feedback

    Can’t find what you’re looking for?

    Pilot’s local support team is here for you.

    Contact Support